Maintenance; General; Daily Cleaning; Replacing A Display Light - Hatco PW Série Manuel D'installation Et D'utilisation

MAINTENANCE

General

Hatco Plate Warmers are designed for maximum durability and
performance, with minimum maintenance.
WARNING
ELECTRIC SHOCK HAZARD:
• Turn OFF power switch, unplug power cord/turn off
power at circuit breaker, and allow unit to cool before
performing any cleaning, adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• This unit is not "jet-proof" construction. Do not use
jet-clean spray to clean this unit.
• Do not steam clean or use excessive water on unit.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment.
This unit has no "user-serviceable" parts. If service
is required on this unit, contact an Authorized Hatco
Service Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350.

Daily Cleaning

To preserve the bright finish of the cabinet, it is recommended
that the exterior and interior surfaces be cleaned daily.
NOTICE
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring its
appearance and making it susceptible to soil accumulation.
1. Move the Power I/O (on/off) Switch to the O (off) position
and allow the unit to cool.
2. Wipe the exterior and interior of the unit with a clean, non-
abrasive cloth.
• Hard to reach areas may be cleaned using a small
brush and mild dish soap.
• Stubborn stains may be removed with a good stainless
steel cleaner or a non-abrasive cleaner.

Replacing a Display Light

The display light consists of an LED light channel that
illuminates the warming area. This light must be replaced by
an Authorized Hatco Service Agent.
8
English
Form No. PWM-0721