Panasonic WV-CW970 Mode D'emploi page 57

Problem
The camera movement
mode (OFF, SEQ,
SORT, AUTO PAN,
PATROL, AUTO
TRACK) setting
changes.
Camera position is
different from the
preset position setting.
Picture is different from
the position setting.
Upper part of the picture
is black when the camera
is in a horizontal
orientation.
Camera suddenly starts
to pan by itself.
Auto tracking does not
move the camera when
the target moves.
Cause and Recommended Action
• Check the self return function.
• Perform REFRESH from the special setup menu.
• Adjust the picture using the preset menu and a
scene file.
• This is caused by the camera's internal cover. It
does not indicate malfunction.
• If the cleaning function is turned on, this is normal
does not indicate
CLEANING settings.
• If the cleaning function is not turned on, this
symptom could be due to noise.
• Check the camera installation height setting.
An incorrect installation height setting can cause
malfunction.
Input the camera and target area heights correctly.
• Check if the area the target is in has been masked.
• Check the AUTO RELEASE setting.
If a setting has been configured, tracking will terminate
automatically after the preset time has expired.
• SENSITIVITY may be set too low.
Use a higher SENSITIVITY setting.
• The target size may be too small.
Adjust the view angle to increase the size of the
target.
-57-
malfunction. Check
Reference Pages
35
48
25-26
40
40
the
7, 9
41
42
42
41
41