Agilent Technologies Turbo-V 300 ICE Mode D'emploi page 244

17 Technical Information
Use
If PRINT is selected and a printer is connected on RS 232/422 line, an
unidirectional communication is established and every minute the
data are sent to the printer, even if the pump is not running.
The set of data available are:
Figure 31
244/260
Pump speed KRPM
Pump temperature
Pump current A
Pump power W
S1 condition
S2 condition
Confirm the selection by pressing the PUMP CURRENT push-
button.
In this way you enter into an operating phase named "Monitor
Relay Programming" described later.
Enter the value by pressing the PUMP CURRENT push-button.
Turbo-V 300 ICE Controller User Manual / 87-900-902-01 (M)