Agilent Technologies Turbo-V 300 ICE Mode D'emploi page 240

17 Technical Information
Use
If necessary press CYCLE NUMBER to select YES or NO. The
controller is factory set to NO.
F
S
Figure 26
where: XXXXXX = means the word FRONT. REMOTE, or SER
depending on the last selection.
The controller is factory-set for FRONT panel operation. SER will
only be displayed if the optional serial card is installed.
240/260
Enter the selection by pressing the PUMP CURRENT push-button,
and the display shows:
R O N T
E L E C
Turbo-V 300 ICE Controller User Manual / 87-900-902-01 (M)
/ R E M O
T I O N :
T E / S E
X X X X X
R
X