Beyerdynamic Opus 910 Mode D'emploi page 67

3.3 Setting up
1. Push down the two snap locks on the right and left of the battery compartment and open it.
Now you can adjust the GT/MT switch
2. Make sure that the transmitter and receiver are on the same frequency.
3. The LED of the TS 910 C will flash for a moment when the transmitter is switched on and
indicates the normal battery status. When the LED fails to flash, there is no battery inserted, the
battery is leaking or inserted incorrectly. The battery status of the TS 910 M can be seen in the
LC-Display.
4. Connect the microphone or instrument to the input socket
3.4 Adjusting the Input Gain
1. Switch on the TS 910 beltpack transmitter with the ON/OFF switch
fully anti-clockwise to minimum gain.
2. Speak into the microphone at the maximum level you expect to use. We recommend you use the
letter "U" as a spoken "U" has a relatively good sine wave shape. Adjust the gain control
the desired gain. On the NE 911/912/914 receiver the AF level must not show any clipping. When
miking instruments, play at the maximum level you expect to use.
and the gain control
8
. Refer to illustration below.
1
.
7
. Turn the gain control
2 7
to
7
67