Publicité
Les langues disponibles
Les langues disponibles
3.
TS 910 Beltpack Transmitter
The TS 910 C beltpack transmitter provides charging contacts and can be powered by the optional
beyerdynamic TS 900 AP rechargeable battery pack. For charging, the SLG 900 charger is available.
With this charger the TS 900 AP battery pack inside the TS 910 C beltpack transmitter can be
recharged only, no standard rechargeable batteries.
3.1
Controls and Indicators
TS 910 C
4
3
2
10
AF input, 4-pin mini XLR for microphones (lavalier, neckworn mics).
1
For connection please refer to chapter 3.5 "AF Connection".
ON/OFF switch (ON = switch to "ON"-position; OFF = switch to "OFF" position).
2
Switch off the transmitter when not in use.
TS 910 C only: Battery status LED to indicate the power on / off and battery status.
3
(a) When the beltpack transmitter is switched on this LED will flash for a moment to
indicate the normal battery status.
(b) When the LED stays red after having switched on the transmitter the battery is to weak and
must be replaced.
Transmitting antenna
4
LC-Display
5
Infrared receiving diode for ACT function.
6
Gain control to adjust input gain.
7
GT/MT switch: When you use electric guitars this switch must be in the "GT" position.
8
In the GT mode the gain control is deactivated. Switch to the "MT" position when you
use condenser and wired microphones. In the MT mode the gain control is activated.
9
Battery compartment and cover for two 1.5 V batteries (AA) or TS 900 AP rechargeable battery pack.
10
TS 910 C only: Charging contacts for TS 900 AP battery pack only (not supplied).
Removable belt clip can be rotated 360°. To remove use a screwdriver at a 45° angle.
11
64
5
1
6
7
TS 910 C
8
9
11
Publicité
