Victron energy BLUE POWER BlueSolar MPPT 150/35 Manuel page 13

5. Specifications
BlueSolar charge controller
Battery voltage
Maximum battery current
Maximum PV power, 12V 1a,b)
Maximum PV power, 24V 1a,b)
Maximum PV power, 48V 1a,b)
Maximum PV open circuit voltage
Peak efficiency
Self consumption
Charge voltage 'absorption'
Charge voltage 'equalization'
Charge voltage 'float'
Charge algorithm
Temperature compensation
Protection
Operating temperature
Humidity
Maximum altitude
Environmental condition
Pollution degree
Data communication port and
remote on/off
Colour
Power terminals
Protection category
Weight
Dimensions (h x w x d)
Safety
1a) If more PV power is connected, the controller will limit input power to
500W resp. 1000W, resp 2000W
1b) PV voltage must exceed Vbat + 5V for the controller to start.
Thereafter minimum PV voltage is Vbat + 1V.
MPPT 150/35
12/24/48V Auto Select (36V: manual)
500W (MPPT range 15V to 130V)
1000W (MPPT range 30V to 130V)
2000W (MPPT range 60V to 130V)
Less than 10mA
Default setting: 14,4V / 28,8V / 57,6V
Default setting: 16,2V / 32,4V / 64,8V
Default setting: 13,8V / 27,6V / 55,2V
multi-stage adaptive (eight preprogrammed algorithms)
-16mV / °C resp. -32mV / °C
Battery reverse polarity (fuse, not user accessible)
Output short circuit / Over temperature
-30 to +60°C (full rated output up to 40°C)
95%, non-condensing
Indoor, unconditioned
See the data communication white paper on our
ENCLOSURE
Blue (RAL 5012)
13mm² / AWG6
IP43 (electronic components)
IP 22 (connection area)
130 x 186 x 70mm
STANDARDS
35A
150V
98%
(adjustable)
(adjustable)
(adjustable)
2000m
PD3
VE.Direct
website
1,25kg
EN/IEC 62109
11