Bosch TWK11 N Serie Mode D'emploi page 10

en
Congratulations on the purchase of
your new Bosch appliance. You can find
further information about our products
on our website.
Parts and controls
1 Catch for opening the cover
2 I/O On/Off switch
3 Jug with base made of stainless steel
4 Jug made of stainless steel
5 Indicator light
6 Water level indicator
7 Base with cord tidy
Important: The jug should only be used
with the base supplied.
■ The kettle should only ever be filled
with water. Milk or instant products will
burn and damage the appliance. Never
operate the kettle without water or overfill:
observe the 0,25 and 1,7 / MAX markings.
If the kettle is too full, the water will boil
over!
Before using for the
first time
■ Remove any stickers or film.
■ Unwind the cord to the required length
and plug in.
■ Fill the jug with water and bring to the boil
twice to clean it thoroughly.
■ When the water comes to the boil for
the first time, add a tablespoon of white
vinegar.
Boiling water
■ Fill the jug with fresh water through the
spout or the opened lid (pull the catch
towards the handle).
■ Read the quantity off the water level
indicator. Do not fill with less than
0.25 litres or more than 1.7 litres of water!
■ Press down on the lid to close and place
the jug on the base.
■ Move up the switch, the indicator light will
light up. The water is heated.
■ The kettle switches off automatically once
the water has boiled.
8
The appliance can also be switched off at
any time by pressing down the I/O On/Off
switch.
Attention: If you lift the jug from the base
and replace it before the water has boiled,
the kettle will not continue heating.
Notes:
■ Only operate the kettle with the lid closed
or the kettle will not switch off.
■ For reasons of physics condensation may
form on the base. This is normal, and the
jug is not leaking.
■ After boiling, let the kettle cool down for
5 minutes before refilling.
■ Do not turn on the appliance if the jug
is empty. Otherwise the overheating
protection will trip and the appliance will
switch off automatically.
Cleaning and maintenance
W Risk of electric shock!
Never immerse the appliance in water or
place it in the dishwasher!
Do not steam-clean the appliance.
■ Pull out the mains plug.
■ The jug and base should only be wiped
down on the outside with a damp cloth.
Do not use harsh or abrasive detergents.
■ Rinse the jug with clean water.
Descaling
Regular descaling:
■ prolongs the life of the appliance.
■ ensures that it functions properly.
■ saves energy.
Descale the jug with vinegar or a
commercially available descaling agent.
■ Fill the jug up to the 1,7 / MAX mark with
water without vinegar or descaling agent
and bring to the boil.
■ Then add a small amount of white vinegar
to the hot water and let the kettle stand
for several hours. You can also use a
descaling agent instead according to
the manufacturer's instructions (observe
safety instructions).
■ Rinse the jug with clean water.