Attach Cleaning Pad - ECOVACS ROBOTICS WINBOT 850 Mode D'emploi

3. Operating WINBOT 8
Remove the Bumper Rail protection strips on
both sides of WINBOT 8 before first use.
Please ensure there is a 15cm (5.9") clearance between the glass and obstacles in the room like
curtains or furniture.
WINBOT 8 can clean horizontally mounted glass but only when using the Direction Control
Buttons on the Remote Control.
WINBOT 8 can clean glass mounted at an angle but may not operate normally; in such a case,
a person should be in the vicinity to assist should there be a problem.
Do not use WINBOT 8 upside down.
Please refer to the manufacturer's care and cleaning instructions before using WINBOT 8 on glass
with an uneven surface, such as frosted, textured, patterned, or coated glass. ECOVACS ROBOTICS
cannot be responsible for damage due to improper use on these surfaces.
3.2 Attach the Cleaning Pad
Turn WINBOT 8 over and attach the Cleaning Pad
to the bottom of WINBOT 8 smoothly. The white
side of the Cleaning Pad attaches to the Velcro,
and the gray microfiber side faces out. Make sure
the Cleaning Pad does not cover the Squeegees or
Edge Detection Sensors.
* The Cleaning Pad is not completely square
and if attached improperly, covers part of the
Squeegees.
8
EN