1. General presentation
iCare is a combined HD CMOS camera and LED light source in a single control unit, designed for use by qualified
gynecologists when performing surgical endoscopy or diagnostic procedures.
It includes all the following elements:
- a control unit that contains a 64 Watts LED light source,
- an HD CMOS sensor with its 22mm C-mount focal length lens, 3 pre-programmed buttons, 2.99mm
cable, connector and sealing cap,
- an EU power cable,
- an HDMI cable,
- a USB key,
- two WiFi keys that allow our imagyn application to work properly (for more information on the imagyn
software, please refer to the corresponding instructions for use).
On the camera side, it is a 1/4'' colour CMOS mono HD camera with remote electronics. Its small ergonomic sen-
sor, automatic shutter, sensitivity, excellent resolution and exceptional colour rendering make it the ideal medical
tool.
On the light source side, this LED source is specially designed for use in various endoscopic diagnostic or surgical
applications. Its ease of use and powerful lighting make it the ideal multidisciplinary medical tool.
To get the most out of iCare while taking all the necessary precautions, it is essential that you read this manual.
Phrases with the
symbol correspond to points that require special attention.
Phrases with the
symbol are information.
This equipment was delivered to you in a cardboard box. Keep it for possible transport.
2. Safety instructions
2.1.
General instructions
- Read the instructions for use.
- Comply with the conditions of use and storage.
- The unit may only be opened by a competent technician authorised by the manufacturer.
- Do not insert metal objects into the unit to avoid electric shock, fire, short circuit or dangerous emission.
- Do not expose the unit to water splashes or in a place that is too humid.
- Use only accessories supplied with the unit or offered as an option by the manufacturer.
- Do not place heavy objects on the unit.
- This unit is not sterile.
- If the power cord is damaged, turn off the power immediately. It is dangerous to operate this unit with a
damaged cord. To disconnect the cord, pull it by the plug. Never pull on the cord itself.
- Unplug the unit from power if it is not going to be used for a few days or more.
- Ensure sufficient air circulation to avoid overheating inside the unit: at least 15cm all around the unit.
Do not cover it and make sure that the feet of the unit are present.
D900 700 053 B
Instructions for use: iCare imaging station
Rev 09/2018
delmont
imaging
4