Publicité
Les langues disponibles
Les langues disponibles
Door diaphragm
CAUTION
Use bleach carefully and be sure to follow the bleach manufacturer's use and care instructions.
Recovery from freezing
The washer may freeze when the temperature in its location drops below 32 °F (0 °C).
1. Turn off the washer, and then unplug the power cord.
2. Pour warm water over the water tap to loosen the water hose.
3. Disconnect the water hose, and then soak it in warm water.
4. Pour warm water into the drum and leave it for about 10 minutes.
5. Reconnect the water hose to the water tap.
NOTE
If the washer still doesn't operate normally, repeat the steps above.
Care for an extended period of non-use
Avoid leaving the washer unused for an extended time. However, if you intend to leave the washer unused
for a long period of time, follow the directions below:
1. Press Power, and then turn the Cycle Selector to RINSE+SPIN.
2. Empty the drum, and then press and hold Start/Pause (Hold to Start).
3. When the cycle is complete, close the water taps and disconnect the water hoses.
4. Turn off the washer, and then unplug the power cord.
5. Open the door to let air circulate through the drum.
Untitled-1 49
A
1. Open the door, and then empty the drum.
2. Combine 3/4 cups of liquid chlorine bleach and 1
gallon of warm tap water.
3. Wearing rubber gloves, use a soft, clean cloth
dipped in the water and bleach solution to clean the
diaphragm.
4. Let stand 5 minutes, and then wipe up and dry well.
English 49
2024-01-18
3:06:11
Publicité
