Publicité
Les langues disponibles
Les langues disponibles
My pool cover sinks, is it a defective?
No, it's normal, and it will not affect the function of the pool cover.
Winterizing your Above Ground Pool
Your pool can be easily emptied and stored in a safe place during the winter. However, many
people choose to leave their pool up year round. In areas where freezing temperatures occur,
there is risk of ice damage. It is recommended to drain, disassemble and store the pool in a safe
place when temperatures drop below 32 degrees Fahrenheit. See "How To Drain Your Pool"
section. Clean pool water thoroughly (If Easy Set Pool make sure the top ring is properly
inflated). Remove the skimmer (if applicable) or any accessories attached to the threaded strainer
connector. Replace strainer grid if necessary. Be sure all accessories parts are clean and
completely dry before storage. Plug the Inlet and Outlet fitting from the inside of the pool with
the plug provided (sizes 10' and 12'). Close the Inlet and Outlet Plunger Valve (15', 18', and 24').
Remove the ladder (if applicable) and store in a safe place. Be sure the ladder is completely dry
before storage. Remove the hoses that connect the pump and filter to the pool. Add appropriate
winter chemicals. Consult your local pool dealer as different regions vary greatly. Cover pool
with Intex Pool Cover. IMPORTANT: INTEX POOL COVER IS NOT A SAFETY COVER.
Clean and drain pump, filter housing and hoses. Remove and discard old filter cartridge (keep a
spare cartridge available for next season). Bring pump and filter parts indoors and store in a safe
and dry area, preferably heated. STORING POOL FOR WINTER After draining pool, dry pool
liner completely (100%). Sprinkle talcum powder on liner to prevent vinyl from sticking together
and to absorb any water you may have missed. Roll pool liner to avoid creases and relocate to
storage area. Place it in original carton if you saved it. Keep all small parts together with filter
pump, manual, and pool, and then place in an area that will remain at room temperature
throughout the storage season.
What are the correct steps to insert the flow reduction adapter into the strainer (for
rectangular metal frame pool 12'x24'x48" only)?
Remember to always turn off or unplug the pump before servicing. From inside the pool,
unscrew the strainer grid from the threaded strainer connector, insert the flow reduction adapter
into the threaded strainer connector, and then screw the strainer grid back on the threaded
strainer connector.
My pool has a milky color, do I need to change the water or is it treatable?
Water condition varies from country to country, states, region, and within specific zones and
areas. In some regions the water could be "hard water", this is because the water contains
excessive minerals, such as calcium and magnesium, thus causing the water to adopt a milky
color. Check your local pool supply store for advice on water treatment and balance.
Why are there holes in the cover? Does INTEX distribute a cover without holes?
Publicité
