Haier QPCA10 Manuel D'utilisation Et Instructions D'installation page 5

CONTROLS
Features and appearance will vary.
Lights next to the touch pads on the air conditioner control panel indicate the selected settings.
B
A. Control Panel Display
Displays the Set Temperature in degrees Fahrenheit
or degrees Celsius. The corresponding indicator light
will illuminate.
B. Power Button
Turns ON/OFF power to the air conditioner.
NOTE: Turning off power by pressing the Power button
does NOT disconnect the appliance from the power
supply.
• Press the Power button. The Power indicator will
illuminate.
C. Mode Button
Press the Mode button to toggle among the operating
options. The corresponding indicator will illuminate:
Heat (on some models) - Heats the room to the set
temperature
Cool – Cools the room to the set temperature
DRY – Reduces the humidity in the room
Fan – Circulates the air in the room without cooling
D. Timer / Temperature Set Controls
Adjusts the Temperature or Hours in Time Delay.
To Set the Temperature:
The temperature can be set between 64ºF and 86ºF (17ºC
and 30º C) when the air conditioner is in Cool mode.
1. Press the Mode button until the Cool mode is selected.
2. Press the Up Arrow or Down Arrow buttons to select the
Temperature.
NOTE: The temperature cannot be set when the air
conditioner is in either Fan or DRY mode.
49-5000614 Rev. 1
A
C
D
E
E. Fan Speed Button
The fan speed can be adjusted from Low, Medium, to High
speed when the air conditioner is in operation.
NOTE: The fan speed cannot be adjusted when the unit is
in DRY mode.
• Press the Fan Speed button to toggle among the three
speeds. The corresponding fan speed indicator will
illuminate.
1. Continuous Fan Mode
To activate continuous fan mode, press and hold Fan
Speed button for 3 seconds and release. "CF" will
show on display for continuous fan mode. When set
temperature is achieved, indoor fan will continue to run.
F. Timer Button
Program a time from (1-hour to 24-hours) for the air
conditioner to turn Off or On. When a Time Delay is
programmed, the Timer indicator light will illuminate.
While the air conditioner is operating:
1. Press the Timer button.
2. Press the Up/Down arrow buttons to select the number of
hours you want the air conditioner to continue to operate
before turning Off.
NOTE: Wait approximately 5 seconds for the Turn-Off time
to be saved.
While the air conditioner is off:
1. Press the Timer button.
2. Press the Up/Down arrow buttons to select the number
of hours you want the air conditioner to remain off before
turning On.
NOTE: Wait approximately 5 seconds for the Turn-On time
to be saved.
To cancel the timer:
• Press the Timer button once, the hours remaining will
flash, press the timer button again and the timer will be
canceled.
F
5