Best KEX222 Mode D'emploi page 9

INSTALL THE HOOD
1. Remove the wiring box.
2. Remove the tape located on the damper.
3. Hang the hood from the brackets through
the rectangular cut-outs on the back of the
hood. Cut-outs are larger than the brackets
to allow for horizontal adjustment.
The bottom of the hood should be 24" to 30"
above the cooking surface.
4. Height adjustment screws provide vertical
adjustment.
5. Depth adjustment screws provide
horizontal adjustment.
6. Secure the hood with mounting screws
(4,8x38mm). Use drywall anchors, provided,
if wall studs or framing are not available.
7. Replace the wiring box.
REMOVE THE
WIRING BOX
MOUNTING
SCREWS
(4,8x38mm)
MOUNTING
SCREWS
(4,8x38mm)
HEIGHT ADJUSTMENT SCREWS
- 9 -
REMOVE THE TAPE
RECTANGULAR
CUTOUTS
MOUNTING
BRACKETS
WALL
FRAMING
DEPTH ADJUSTMENT
SCREWS