SOMFY 9.6V NIMH NAKED BATTERY Notice page 6

EN
4) Wait until the LED turns green: the battery charging
phase is complete.
5) Disconnect the charger from the mains socket.
6) Disconnect the external battery charger connector (E)
from the drive connector (D).
7) Connect the solar panel connector (C) to the drive
connector (D).
3. USE AND MAINTENANCE
3.1. CHARGING THE BATTERY
After installing and commissioning the RS100 SOLAR io kit (drive, Somfy battery, Somfy solar
panel), the battery charges with electrical energy via the solar panel.
The electrical energy transmitted by the solar panel is stored by the battery to supply the drive.
It is possible to check the real state of the battery charge level via the TaHoma application. To do this,
beforehand, an order to raise the motorised product is necessary to update this level.
3.2. PROTECTING THE BATTERY AGAINST EXCESSIVE DISCHARGE.
3.2.1. Normal voltage
The drive works normally.
3.2.2. Response to low battery
When the Up, my or Down button is pressed, the drive
checks the battery voltage:
if it is low (or the shutter is very heavy), the drive can
reduce its speed to preserve the battery life, but if the
voltage is too low, please refer to the following paragraph.
6
9.6V NIMH NAKED BATTERY - 16.8V NIMH NAKED BATTERY
©
Copyright 2022 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
4
5
6
7
OK
D
E
C
D