Evolution COMPACT24HP Manuel D'utilisation page 14

Fig. 4a
Fig. 4b
Fig. 5
14
The two (2) short thumb screws are used to attach the
Upper Section of the handle to the Middle Section.
• Carefully slide the Upper Section of the handle over
the Middle Section and align the holes.
• Insert the thumb screws through the Upper Section
handle and screw them into the captive nuts within
the Middle Section.
The Hulk Electro is supplied with 3 cable clips to safely
route the power cable up the handle frame. These
must be fitted. Failure to do so will void your warranty.
Locate them on the same side as the power trigger
and space them as shown in Fig.4a & 4b
WARNING: Take care to ensure that the power
cable from the Safety Switch down to the motor is
'free' and not 'trapped' during the assembly process.
Initial filling and checking the oil level –
Hulk Petrol
WARNING: This machine does not come filled
with oil. No attempt to start the engine must be
made until the crankcase is filled to the correct level
with the correct grade of oil.
Note: Oil (provided) should be poured into the
machine through the Oil Filler/Level Cap. Oil capacity
is approximately 0.25 litre of 10W 30 automotive oil
(available at all good motor factors and most petrol
stations). For some non-temperate climatic areas an
alternative grade of oil may be preferable – consult
your supplier.
The Oil Filler Cap unscrews from the machines engine
casing and incorporates an oil level dip stick. (Fig. 5)
Take care not to spill any oil.
www.evolutionpowertools.com