Publicité
Les langues disponibles
Les langues disponibles
The dealer needs to know the exact model
designation of your power tool in order to select the
correct accessory.
See page 4.
A Roughing disc (always use with safety guard
attached)
B Louver disc (always use with safety guard
attached)
C Parting safety guard.
D Parting disc (always use with parting safety
guard attached)
E Diamond discs (always use with parting safety
guard attached)
F Parting safety guard with guide slot (place on
machine and secure with screws.) (with adapter
for connection to a suitable dust extractor for
extraction of stone dust generated when cutting
stone slabs.)
G Hand guard (for attaching under the additional
side-mounted handle.)
H Extension piece (for working with supporting
discs. Increases the distance between the
spindle and the supporting disc by approx.
35 mm)
I Supporting disc for fibre discs (always attach
using the supporting disc clamping nut
supplied.) (always use with the hand guard
attached.)
J Fibre discs (always use with the hand guard
attached.)
K Semi-flexible sanding discs (for use with elastic
supporting disc 6.23279) (always use with hand
guard attached.)
L Sanding pad with Velcro (always use with the
hand guard attached.)
M Adhesive sanding disc (always use with the
hand guard attached.)
N Adhesive fleece (always use with the hand
guard attached.)
O Steel wire brushes (always use with the hand
guard attached.)
P Adjusting nut (10)
For complete range of accessories, see
www.metabo.com or refer to the main catalogue.
11. Repairs
Repairs to electrical tools must be carried out
by qualified electricians ONLY!
If the connection lead is damaged, it must be
replaced by a special connection lead.
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.
12. Environmental Protection
The generated grinding dust may contain harmful
substances. Dispose appropriately.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
13. Technical Specifications
Explanation of details on page 3. Subject to
changes serving technical progress.
D
= Maximum sanding disc diameter
max
t
= max. permitted thickness of clamping
max,1
shank on accessory when using clamping
nut (10)
t
= Roughing disc/Parting disc:
max,3
max. permitted thickness of accessory
M
= Spindle thread
l
= Length of the grinding spindle
n
= No-load speed (maximum speed)
P
= Nominal power input
1
P
= Power output
2
I
= Current at 120 V
120 V
m
= Weight without mains cable
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. Depending on the operating
conditions, the condition of the power tool or the
accessories, the actual load may be higher or lower.
For assessment purposes, please allow for breaks
and periods when the load is lower. Based on the
adjusted estimates, arrange protective measures
for the user e.g. organisational measures.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a
= Vibration emission value
h, SG
(surface grinding)
a
= Vibration emission value
h, DS
(disc sanding)
K
= Uncertainty (vibration)
h,SG/DS
Typical A-effective perceived sound levels:
L
= Sound pressure level
pA
L
= Acoustic power level
WA
K
, K
= Uncertainty
pA
WA
During operation the noise level can exceed
80 dB(A).
Wear ear protectors!
ENGLISH en
11
Publicité
