Publicité
Les langues disponibles
Les langues disponibles
SAFETY WARNINGS AND INSTRUCTIONS: DRILLS
1. Hold drill firmly with one hand on the grip and the other hand on the bottom of the
battery pack.
2. When attaching accessories in the drill chuck, hand tighten the keyless chuck firmly.
WARNING:
Drill may stall (if overloaded or improperly used) causing a twist. Always
expect the stall. Grip the drill firmly with both hands to control the twisting action and
prevent loss of control which could cause personal injury. If a stall does occur, release
the trigger immediately and determine the reason for the stall before re-starting.
installing and removing the battery Pack from the tool
WARNING:
Make certain the lock-off button is engaged to prevent switch actuation
before removing or installing battery.
TO INSTALL BATTERY PACK: Insert battery
pack (7) firmly into tool until an audible click is
heard as shown in figures B. Ensure battery
pack is fully seated and fully latched into
position.
TO REMOVE BATTERY PACK: Depress the
battery release button as shown in figure C
and pull battery pack out of tool.
OPERATING INSTRUCTIONS
TRIGGER SWITCh & REvERSING BUTTON (FIGURE D)
•
The drill is turned ON and OFF by pulling
and releasing the trigger switch (1). The
farther the trigger is depressed, the higher
the speed of the drill.
•
A forward/reverse control button (2)
determines the direction of the tool and
also serves as a lock off button.
•
To select forward rotation, release the
trigger switch and depress the forward/
reverse control button to the left.
•
To select reverse, depress the forward/
reverse control button the opposite
direction.
NOTE: The center position of the control
button locks the tool in the off position.
When changing the position of the control
button, be sure the trigger is released.
B
C
D
2
1
8
Publicité
