Télécharger Imprimer la page

Jennair JUBFL242HM Guide D'utilisation Et D'entretien Et Instructions D'installation page 6

Publicité

Les langues disponibles

Les langues disponibles

PRODUCT DIMENSIONS
OVERALL PRODUCT
Width (up to hinge cover)
Height (up to hinge cover)
Depth - NOIR™ (no handle)
Depth - RISE™ (no handle)
Raw Door Height
NOTE: The power cord is 60" (152.4 cm) long.
237/8"
(60.72 cm)
343/8"
(87.32 cm)
6
ELECTRICAL REQUIREMENTS
237/8" (60.72 cm)
343/8" (87.32 cm)
233/4" (60.36 cm)
235/8" (60 cm)
305/8" (77.75 cm)
Depth
(no handle)
Before you move your beverage center into its final
location, it is important to make sure you have the proper
electrical connection.
RECOMMENDED GROUNDING METHOD
A 115 V, 60 Hz, AC only, 15 or 20 A fused, grounded
electrical supply is required. It is recommended that a
separate circuit serving only your beverage center be
provided. Use an outlet that cannot be turned off by a
switch. Do not use an extension cord.
NOTE: Before performing any type of installation,
cleaning, or removing a light bulb, unplug beverage
305/8"
(77.75 cm)
center or disconnect power.
UNPACK THE BEVERAGE CENTER
Before using your beverage center, all packaging
materials should be removed and the interior should be
cleaned.
 Remove tape and glue residue from surfaces before
 Do not use sharp instruments, rubbing alcohol,
 Dispose of and/or recycle all packaging materials.
 After all packaging materials have been removed,
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
center.
Failure to do so can result in back or other injury.
turning on the beverage center. With your fingers,
rub a small amount of liquid dish soap over any
adhesive and wipe with warm water to remove.
flammable fluids, or abrasive cleaners to remove
tape or glue. These can damage the surfaces of
your beverage center. For more information, refer
"Beverage center Safety" section.
clean the inside of your beverage center. Refer the
cleaning instructions in "Cleaning" section.
beverage

Publicité

loading