Texas A/S TX 601 Manuel De L'utilisateur page 22

Maintaining the chain housing
The chain housing is lubricated with 0.2 litres of TEXACO Multifak EP0 grease at the factory.
This process does not need to be repeated.
Always stop the motor before doing maintenance work.
Engine
The machine comes without oil or petrol. Remember to fill motor oil before using the
machine.
Remember that fuel is very flammable.
Replace worn or damaged mufflers as needed.
Do not replace or adjust the motor settings.
For correct use and maintenance of the engine, consult the accompanying engine manual.
Storage
If the machine is likely to be stored unused for prolonged periods, follow the instructions
below. This will ensure longer machine lifetime.
Empty the motor of fuel, follow the motor's instruction manual and other storage instructions.
Once the motor has cooled, use a garden hose to wash off soil and grime. Remove any
grass, etc. from the rotor shaft. The chassis number should only be cleaned with a damp
cloth, otherwise it can be damaged. Avoid using a high-pressure washer during cleaning.
Wipe the tiller over with a damp cloth so that all surfaces are clean. Wipe the surfaces down
with an oily cloth to prevent rust.
You should always store your machine in a clean and dry place, away from flammable
objects.
Replace damaged parts before storing the machine.
Accessories
Side guards: used for tilling in between crops, such as carrots/potatoes, to avoid
covering the crops in soil. Side guards can also be used for tilling along a wall or
stone path, or in soft soil.
Scarifier: used to aerate the lawn and remove underlying dead grass from the
lawn. The grass grows greener and stronger, which prevents the grown of moss.
The rear bracket is necessary for fitting.
Push hoe: used to loosen the soil and thus remove weeds on paths and
entrances. The rear bracket is necessary for fitting.
15
Figure
25
Figure
18 / 30
Figure
17 / 30