Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
REQUIRED DAILY CHECKLIST
See Figure 9, page 16.
Disconnect the air supply from the tool and remove all
fasteners.
Check all screws, nuts, bolts, and pins on the tool. If any
of these are loose, they must be tightened with the ap-
propriate size wrench.
Press the workpiece contact against a workpiece to
ensure that it moves smoothly.
With the workpiece contact depressed, pull the trigger.
The trigger should move smoothly, without binding.
While the tool is not loaded, connect the appropriate air
supply (at 70 psi) to the tool.
Select Single Sequential Actuation mode ( ). No air
should leak from the tool.
• Without pulling the trigger, press the workpiece con-
tact against a workpiece several times. The tool must
not operate.
• With the workpiece contact not engaged on the work-
piece, point the tool down and away and pull the trig-
ger several times. Hold the trigger in this position for
a minimum of 5 seconds. The tool must not operate.
ACCESSORIES
To order parts and maintenance kits, call 1-866-539-1710.
Oil and Wrench Kit...........................................................................................................................................079077052703
Driver Maintenance Kit ....................................................................................................................................079077052701
Overhaul Kit .....................................................................................................................................................079077052702
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments
or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not
recommended can result in serious personal injury.
• Press the workpiece contact firmly against the work-
piece and pull the trigger. The tool must operate.
• With the workpiece contact still depressed, release
the trigger. The driver must return to its up position.
Select Contact Actuation mode (
• With the workpiece contact not engaged on the work-
piece, point the tool down and away. Pull the trigger.
The tool must not operate.
• Keeping the trigger fully depressed, push the workpiece
contact against a workpiece. The tool must operate.
If the tool successfully meets all the requirements in this
checklist, it is ready for use. Set the trigger on the tool
to operate in the manner that best fits your application.
Load the proper fasteners for the desired application.
Set the depth of drive according to the "Depth-Of-Drive
Adjustment" section in this manual.
Repeat this checklist before using the tool each day, or
if the tool is dropped or damaged in any way.
13 – English
).
Publicité
