shark ZU700C DuoClean Guide D'utilisation page 6

MAINTENANCE
Zero-M Technology
™
Zero-M technology actively removes hair wrap from your brushroll while you vacuum. If you run over
a hard or sharp object or notice a noise change while vacuuming, check for blockages or objects
caught in the brushroll.
CLEANING THE BRUSHROLL
To open the brushroll garage, slide both release buttons on the floor nozzle away from you,
towards the back of the nozzle, then lift off the lid. Clear away any objects or debris.
To close the brushroll garage, insert the 3 tabs on top of lid into the 3 slots in the nozzle, then
push down on both sides of lid until it clicks securely into place.
NOTE: If any hair is wrapped around the brushroll, extending cleaning time will allow Zero-M technology to remove it for you. If
some fibers remain wrapped around brushroll after continued use, carefully cut debris with scissors and remove from brushroll.
CLEANING THE SOFT ROLLER
To remove the Soft Roller from the nozzle, lift it
out by the pull tab. Tap loose debris off the Soft
Roller. Use a dry towel to wipe the Soft Roller
clean, or to remove any debris caught in the
teeth behind the Soft Roller.
s h a r kc l e a n . c o m
Hand wash the Soft Roller as needed. Use only
water, and let air-dry completely for at least
24 hours. Reinsert the Soft Roller under the
rubber bumper in the front of the nozzle until it
clicks into place.
CHECKING FOR BLOCKAGES
Detach hose from vacuum pod, and check hose
and opening on back of pod for blockages.
Detach wand from floor nozzle, tilt nozzle neck
back, and check opening for blockages.
Detach wand from floor nozzle and handle, and
check both ends for blockages.
Detach handle from wand and hose from the
vacuum pod, and check openings for blockages.
s h a r kc l e a n . c o m