Makita DCL286F Manuel D'instruction page 10

You can store the sash nozzle in the nozzle holder.
2
Fig.13
► 1 . Nozzle holder 2. Sash nozzle
CAUTION:
Be careful not to trap finger(s)
between the sash nozzle and the nozzle holder.
Trapping finger(s) may cause injury.
Sash nozzle + Extension wand
(Straight pipe)
In tight quarters where the cleaner itself cannot
squeeze in, or in high places hard to reach, use this
arrangement.
Fig.14
► 1 . Sash nozzle 2. Extension wand (Straight pipe)
3. Cleaner body
Cleaning without nozzle
You can pick up powder and dust without nozzle.
Fig.15
1
3
1
2
10 ENGLISH
For picking up dust on a floor in a standing position, it is
convenient to attach the extension wand to the cleaner.
Fig.16
► 1 . Extension wand (Straight pipe)
Disposing of dust
CAUTION:
Empty the dust case before it
becomes too full, or the suction force weakens.
CAUTION:
Be careful not to trap finger(s)
between the dust case and cyclone body when
reassembling.
Dispose of accumulated dust as follows before it
exceeds the dust disposal line.
1. Point the cleaner head downwards, hold the dust
case firmly, and then pull it apart from the cyclone body
while pressing and holding the release buttons on both
sides of the dust case.
1
Fig.17
► 1 . Dust disposal line 2. Dust case 3. Release but-
tons 4. Mesh filter
1
3
2
4