Publicité
Les langues disponibles
Les langues disponibles
Setting the Temperature Control
• Your unit has one control for regulating the temperature. The temperature control is located on the outside of
the refrigerator compartment door.
• The first time you turn the unit on, the unit will start at the factory-set default temperature, which is 38ºF in the
refrigerator compartment and -02ºF in the freezer compartment.
• The first time you turn the unit on, adjust the temperature in the refrigerator compartment to 34ºF and run for
at least 4 hours before placing food inside. This will ensure that the freezer compartment is thoroughly chilled
and the refrigerator compartment is stabilized before food is placed inside. Then adjust the temperature setting
to your desired setting.
• To adjust the temperature in each zone, press the appropriate zone button, and the selected zone will flash
on and off. The temperature will change according to the pre-set temperatures as shown below. You will hear
a bell chime with each press of the control panel buttons.
OPERATING YOUR APPLIANCE
Default is Fahrenheit when power is on.
Press "MODE" button 5 seconds, to switch between °C and °F.
Other buttons use the same method to switch between two modes.
Set temperature range: Celsius degree mode
1.Fridge temperature range: 0~6℃ (Default value 3℃)
2.Freezer temperature range: -23~-15℃ (Default value -19℃)
Set temperature range: Fahrenheit degree mode
1.Fridge temperature range: 32~43°F (Default value 38°F)
2.Freezer temperature range: -10~5°F (Default value -2°F)
•
CONTROL PANEL – CHILD LOCK
The CONTROL PANEL LOCK is designed to prevent any changes to the
settings to the refrigerator.
To enable the CHILD LOCK, press the LOCK button, the CHILD LOCK
icon will turn on.
The control panel will be locked until unlocked at the control panel or
there is a loss of power.
To disable the CHILD LOCK, press and hold the lock button for
approximately 3 seconds until the LOCK icon turns off and the control
panel is working in normal operation mode.
•
CONTROL PANEL – STANDBY
The CONTROL PANEL will go dark after approximately 20 seconds of no
activity.
To reactivate the display, simply press any of the buttons on the control
panel.
14
Publicité
