Continental Fireplaces CBLP42 Manuel Du Propriétaire page 3

1.0 getting to know your appliance
1.1 control access
1.2 rating plate information
2.0 operating your appliance
2.1 initializing the transmitter / battery holder for the first time
2.2 using your appliance
3.0 remote control layout
3.1 general transmitter layout
3.2 temperature display
3.3 flame height
3.4 blower speed
3.5 night light dimmer control
3.6 in the event of a power failure
3.7 continuous pilot / intermittent pilot (CPI/IPI) selection
3.8 low battery
3.9 battery holder / backup installation
4.0 operation
4.1 pilot-on-demand
5.0 clearances around fireplace
5.1 optional heat management system
5.2 clearances around appliance (TV and valuable objects)
6.0 maintenance
6.1 care of glass
6.2 care of plated parts
6.3 safety barrier removal
6.4 door trim removal
6.5 firebox glass door removal
7.0 replacement parts
8.0 accessories
9.0 troubleshooting
10.0 warranty
This owner's manual is written for a complete series of fireplaces that have a variety of different features and speci-
fications. Before reading this manual, be sure you know which model of fireplace that you have. This information
will have been filled out by the installer on the following page and on the rating plate that is permanently attached
to the fireplace (see "rating plate information" section).
This manual is for the:
• CBLP Series (CBLP42, CBLP46 and CBLP56 models)
If required, more detailed technical information is included in the appliance installation manual.
The information throughout this manual is believed to be correct at the time of printing. Wolf Steel Ltd. reserves
the right to change or modify any information within this manual at any time without notice. Changes, other than
editorial are denoted by a vertical line in the margin.
Visit the Continental website for the most current version of your appliance's manual.
Changes, other than editorial, are denoted by a vertical line in the margin.
This appliance is suitable for use with the optional Universal Heat Management system. THIS MANUAL DOES
NOT include detailed information relating the optional sytem. Framing and finishing are NOT the same. For
further details, refer to UHM instructions provided with the kit before starting installation.
table of contents
11
13
17
20
21
22
23
W415-4064 / 04.19.22
EN
5
6
6
7
7
7
8
8
8
9
9
9
9
9
10
10
12
14
15
17
18
18
19
19
3