C-LITE C-VT-C-LIN4 Serie Instructions D'installation page 2

INSTALLATION INSTRUCTIONS
C-VT-C-LIN4 Series
ELECTRICAL CONNECTIONS- STANDARD
FIXTURE
Fixture is equipped with universal volt driver 120-277V
(ie. 120V, 208V, 240V or 277V)
PHASE TO NEUTRAL WIRING 120/277V
1. Connect supply ground to fixture ground (green or
green/yellow) lead.
2. Connect supply common to fixture neutral (white) lead.
3. Connect supply Vin to fixture hot (black) lead.
Tuck all wires carefully into wiring chamber ensuring that no
wires are pinched.
PHASE TO PHASE WIRING 208/240V
1. Connect supply ground to fixture ground (green or
green/yellow) lead.
2. Connect supply L1 (Hot) to fixture neutral (white) lead.
3. Connect supply L2 (Hot) to fixture hot (black) lead.
Tuck all wires carefully into wiring chamber ensuring that no
wires are pinched.
DIMMING
1. If 0-10V dimming is used, connect supply positive
dimming lead to violet positive fixture dimming lead.
Cap off violet dimming lead if dimming is not used.
2. If 0-10V dimming is used, connect supply negative
dimming lead to grey or pink negative fixture dimming
lead.
Cap off grey or pink dimming lead if dimming is not
used.
NOTE: For dimming, use Class 1 wiring methods only.
http://lighting.cree.com/warranty
Document: LPN00856X0001A1_A
Created By: TMT
FCC NOTICE Class A
CAUTION: Changes or modifications not expressly approved could
void your authority to use this equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
CAN ICES-005 (A)/NMB-005 (A)
| 866.924.3645
Date 9-26-2023