Elem Garden Technic CBE1035 Traduction Des Instructions D'origine page 28

The declared vibration total value has been measured in accordance with a standard test method and
may be used for comparing one tool with another that the declared vibration total value may also be used in a
preliminary assessment of exposure.
A warning that the vibration emission during actual use of the power tool can differ from the declared
total value depending on the ways in which the tool is used and of the need to identify safety measures to
protect the operator that are based on an estimation of exposure in the actual conditions of use (taking account
of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in
addition to the trigger time).
ASSEMBLY OF GUARD
The only assembly required for your trimmer is to install guard
1) Remove the cutting head, place the guard on the shaft.
2) Slide the guard over the cutting head along shaft.
3) Fit the guard to the support of the shaft, make sure the guard sits level on the cutting head.
The larger side of the guard should be facing the same direction as the rear handle.
4) Insert the bolt through the hole of support of shaft and the hole of guard, tighten the bolt and
nut with the hexagon spanner.
ASSEMBLY OF SHAFT
1) Push angle regulator to raise the locking pin up, connect the two shafts of appliance and
align
the driving pin the hole.
2) Rotate the shaft of the cutting head to the angle with the two holes of the shaft aligned
together.
3)
Release the angle regulator and let the locking pin lock the two shafts
OPERATION
1. Before use, check that the tools in good working order and that the length of the trimmer line
is correct, as follows:
2. Ensure the switch is at the off position and disconnect the cable plug from the mains supply.
3. Remove the cover of the line cutting blade.
4. Examine the general condition of the tool. Inspect the guard, switch, supply cord and
extension cord. Check for loose screws, misalignment, and binding of moving parts, improper
mounting, broken parts and any other condition that may affect its safe operation. If abnormal
noise or vibration occurs during operation, turn the trimmer off immediately and have the
problem corrected .Do not use a damaged tool and attach a label"DO NOT USE"to the tool.
1). Ensure that you are on a flat surface and have secure footing.
2). Check that the line touches or goes beyond the edge of the guard.