Cleaning And Storage; Troubleshooting - MAXXMEE QSF78 Mode D'emploi

Ceinture ems
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EMS Belt

CLEANING AND STORAGE

Please Note!
After each use, store the device in a
place where children cannot use it.
No liquid must get into the operating
element. Never immerse the operat-
ing element in water!
Do not use any caustic or abrasive
cleaning agents or pads to clean
the device. These may damage the
surfaces.
Remove the operating element (3)
from the belt (1) after use.
Clean the belt in accordance with the
washing label.
Clean the operating element with a
slightly damp, soft cloth.
Store all parts in a dry place which
is protected from moisture, dirt and
direct sunlight and is out of the reach
of children and animals.

TROUBLESHOOTING

If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps below, contact
the customer service department.
Do not attempt to repair an elec-
trical device yourself!
The operating element (3) does not
work. / The display does not show
anything.
The battery is empty.
Charge up the battery.
The operating element (3) repeated-
ly switches off.
There is no contact between the skin and
silicone pads in the belt (1).
Make sure that the silicone pads fit
correctly. There must be skin contact.
There must not be any hairs, clothing,
jewellery etc. between the skin and
silicone pads.
The operating element (3) is not attached
to the belt (1) correctly.
Check whether the operating ele-
ment is correctly attached to the
press studs.
The battery is too weak.
Charge up the battery.
The display shows the mode and
intensity, but no pulses for muscle
stimulation are emitted.
The silicone pads in the belt (1) are not
fi tted correctly.
Keep changing the position of the
silicone pads until the spot with the
strongest muscle contraction has
been found.
The intensity level is set too low.
Increase the intensity level.
The silicone pads are dirty.
Clean the silicone pads.
The battery is too weak.
Charge up the battery.
EN
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

09074

Table des Matières