Best K8087 Mode D'emploi page 12

PREPARE THE HOOD
NON - DUCTED CONFIGURATION, cont'd.
8. Carefully place the lower decorative flue
into the recessed area of the range hood
top. Fig. 7
9. Carefully slide the upper decorative flue
down inside the lower flue.
Note: air vents must be up. Fig. 7
10.Secure the recirculation plenum to the
upper flue with (4) flat head screws.
Fig. 10
INSTALL THE HOOD
Note: at least two people will be required to
mount the hood.
1. Raise the hood into its mounting position.
2. Plug the power cord into the electric wall
receptacle. Tuck excess cord behind the
flue.
3. Align the rectangular opening on the back
of the hood with the wall-mounting
bracket. Gently lower the hood until it
securely engages the bracket. Fig. 11
4. Level the hood with mounting screws
(3.9x9.5mm) and secure with (4) mounting
screws (4.8x38mm). Use drywall anchors
provided if wall studs or framing are not
available. Fig. 11
5. Secure the electrical system plate to the
range hood with (3) mounting screws
(3.9x9.5mm). Fig.12
6. Raise the upper flue until its holes align
with holes in the flue mounting bracket
(located on ceiling). Fig. 13
7. Secure the flue with (2) mounting screws
(3.9x9.5mm). Fig. 13
3.9x9.5mm
SCREWS
ELECTRICAL
SYSTEM
PLATE
FIG. 12
- 12 -
UPPER
FLUE
RECTANGULAR
CUTOUT
MOUNTING
SCREWS
(3.9x9.5mm)
MOUNTING
SCREWS
(4.8x38mm)
3.9x9.5mm
MOUNTING SCREWS
PLENUM
4 FLAT
HEAD
SCREWS
FIG.10
MOUNTING
BRACKET
FIG.11
FIG.13