BH FITNESS SK Line G790TV Instructions De Montage Et Utilisation page 16

PROBLEM
1. The monitor does
not switch on.
2. The monitor
switches on but the
motor fails to start.
3. Walking motion is
jerky on the treadmill
4. The machine stops
(the breaker trips)
5. Electrical shocks
through the handrail.
6. The treadmill belt
skews off centre
Do not hesitate to get touch with the Technical Assistance Service if you have any queries by phoning customer
To order your BH Fitness SK8900TV Commercial Treadmill go here
SK SK
SK SK
LINE
sportkoncept
FAULT FINDING CHART
CHECKS
1) Make sure that the machine is
plugged in, the ON/OFF switch in
position I and that the safety key is
inserted.
2) Check that the current limiter is
pressed in.
3.a) Check that the belt is lubricated.
3.b) Check the tension on the sliding
belt.
3.c) Check the tension on the drive
belt.
4) Check that the band is lubricated
5) Check that the machine is plugged
into an earthed mains socket.
6.a) Check that the machine is level
on the floor
6.b) Check that the machine does
not wobble.
services (see last page in manual)
16
G790TV / G795 TV
SOLUTIONS
1) Plug the machine into the
mains supply.
Set the switch to position I and
insert the safety key.
1) Switch the machine off and
press the circuit breaker in.
2) Lubricate the treadmill band.
3.a) Lubricate the sliding belt.
3.b) Adjust the belt tension.
3.c) Adjust the drive belt tension.
1) Reset the overload button with
the On/Off switch at "0" and
lubricate the treadmill band.
1) Plug the machine into an
earthed mains socket.
1) Use the adjustable feet to level
the machine.