Simons Voss Technologies Digital SmartHandle AX Metal frame Guide Abrégé page 49

Digital SmartHandle AX Metal frame
Door thick-
Area
ness (mm)
S 40 - 42
S 40 - 42
S 43 - 47
S 43 - 47
S 48 - 52
S 48 - 52
S 53 - 57
S 58 - 61
M 60 - 62
M 60 - 62
M 63 - 67
M 63 - 67
M 68 - 72
M 68 - 72
M 73 - 77
M 78 - 81
L 80 - 82
L 80 - 82
L 83 - 87
L 83 - 87
L 88 - 92
L 88 - 92
L 93 - 97
L 98 - 101
XL 100 - 184
18. Slide the O-ring onto the calculated groove.
32
19. Insert the spindle into the door with the ring-free
side as far as it will go.
33
20. For FH: insert the dummy cylinder.
EN
Spindle
Ring posi-
length
tion
(mm)
94 3
104 5
94 2
104 4
94 1
104 3
104 2
104 1
114 3
124 5
114 2
124 4
114 1
124 3
124 2
124 1
134 3
144 5
134 2
144 4
134 1
144 3
144 2
144 1
O-ring is 30–35 mm from
the cut end of the spindle.
NOTE
Feed the blank cylinder into the hole using a screw-
driver
It is difficult to position the blank cylinder correctly, es-
pecially in thick doors.
1. Insert a screwdriver into the hole in the blank cylin-
der.
2. Position the blank cylinder using the screwdriver.
34
35
21. For FH: screw the dummy cylinder firmly into place
(PH2, torque 1.1 Nm).
36
22. Screw the inner handle unit onto the spindle (PH2,
torque 1.1 Nm).
37
23. Screw the escutcheon base firmly into place on the
inside (PH2, torque 1.1 Nm).
38
24. Fasten the grub screws firmly onto both handles
(TX15, torque 5.0 Nm).
39
25. Place the inner handle cover with the notch facing
downwards onto the inner handle escutcheon.
40
26. Place a cover with the notch facing downwards on
the escutcheon base.
41
Fitting is now installed.
9
10. Removing the fitting
ü 1.5 mm hexagonal wrench available.
1. Remove the fitting in the reverse order to installa-
tion.
2. Insert a 1.5 mm hex key into the hole in the spindle
mount in the fitting.
42
3. Bend the hex key to the side where the hole is loc-
ated while pulling on the outside handle.
43
9 Fitting is now removed.
10. Removing the fitting
49 / 92