Publicité
Les langues disponibles
Les langues disponibles
Return to the initial settings
You can carry out a general reset toreturn to the factory
settings:
- the installer settings (grayed out on the start up
menus)
- set-point temperatures,
- default program.
Turn the knob to Shutdown then
press the left-hand button for
10 seconds until init is displayed.
Press OK to confirm or C to
cancel.
Return to the shutdown mode
display.
10 sec.
- 30-
Time Setting
Turn the knob to
.
The days flash.
Press + or - to make your choice,
OK to confirm it and go to the
next setting.
Repeat the operations to set
the hours and minutes.
Turn the knob to exit the setting
mode.
Changing the operating
mode Heating/Cooling
To switch from HEAT mode to
(COOL) mode,from the
AUTO modes, press the
HEAT/COOL button for 3 seconds
If the thermostat does not control
the heat pump, switch it over
manually.
Setting the temperatures (set-points)
Frost Protection setting (
Turn the knob to (
).
Heat mode: setting from 5°C to 15°C (7°C by default)
Hours
Minutes
,
or
)
- 31 -
Day
Publicité
