Elesta RTU 300B Mode D'emploi page 15

CF06 - Control of the change-over input of
the heat pump
The thermostat controls
the change-over of the
heat pump
Press + or - to make your choice, OK to confirm it and
go to the next menu.
CF07 - Cyclic mode
If the receiver is associated with
other X2D domotics products
(transmitters, remote controls,
alarm control unit, etc. excluding
door/window magnetic contacts),
the cyclic mode must be disabled.
Cyclic mode
Press + or - to make your choice, OK to confirm it and
go to the next menu.
No
Yes
Enabled (without domotics products)
Disabled (with domotics products)
- 28 -
CF08 - Association with receiver(s)
On the receiver, press the button
until the LED flashes.
On the transmitter, press + from
the CF06 menu.
The transmitter sends a frame to
the receiver. The X2D symbol is
displayed briefly.
Check that the receiver's LED is
no longer flashing.
The receiver is associated with the transmitter.
Press OK to go to the next menu.
CF09 - Radio test
The transmitter sends a frame to
the receiver every 3 seconds. The
X2D symbol is displayed briefly.
Check that the receiver LED
flashes each time it receives the frames.
To cancel the manual mode, press the C button or turn
the knob.
- 39 -