Bosch DWK65AJ0R Serie Manuel D'utilisation Et Notice D'installation page 14

en Installation instructions
Mark the holes for the appliance bracket.
7.
Drill the holes.
8.
Insert the wall plugs flush with the wall.
9.
10. Screw on the angle bracket for the flue duct.
Screw in the screws for the appliance bracket
11.
loosely; do not tighten them fully.
Preparing the appliance
Open the filter cover if required.
1.
Remove the grease filters.
2.
To avoid causing damage, do not bend the grease
filters.
14
Secure the air pipe connector to the appliance.
3.
Installing the appliance
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
Wear protective gloves.
▶
Remove the protective film from the rear.
1.
Once the appliance is installed, fully remove the
‒
protective film.
Hook on the appliance.
2.
Align the appliance horizontally using screws.
3.
Fit the grease filters.
4.
To avoid causing damage, do not bend the grease
filters.
Establishing the exhaust air connection
(exhaust pipe, 150 mm diameter)
Secure the exhaust pipe to the air pipe connector.
1.
Establish the connection to the exhaust air opening.
2.
Seal the joints.
3.
Establishing the exhaust air connection
(exhaust pipe, 120 mm diameter)
Secure the reducing connector to the air-pipe con-
1.
nector.
2. Secure the exhaust pipe to the air pipe connector.
Establish the connection to the exhaust air opening.
3.
Seal the joints.
4.
Connecting to the power supply
Insert the mains plug into the protective contact
1.
socket.
If a fixed connection is required, follow the instruc-
2.
tions in the section
→ "Instructions for the electrical connection",
Page 12.