Bosch PAM0740 Mode D'emploi page 44

• Remove the basic filter from the appliance,
Fig. 20.
• Insert the double active filter + positioner in
the basic filter as shown on Fig. 22,
remembering that it must be housed on the
lower studs first.
clack!
2
• Install the assembly onto the appliance by
lining the lower studs up with the slots on the
front casing of the appliance and pressing the
top clip in until it clicks into position. The
assembly is fitted properly when it clicks into
position.
• IClose the front flap.
Warning!
Fit only one set of filters onto the support in
order to ensure correct appliance operation.
Note
The front flap can also be removed in order
to clean the appliance or change the filters
more easily.
To do this, open the flap up to the first stop
(the flap opens to a slight angle; Fig. 18)
and pull outwards. In order to refit it, line
the lower studs on the flap up with the
holes on the casing until the studs meet
the clips on the casing.
Cleaning and Maintenance
Fig. 21
Fig. 22
clack!
1
Transportation requirements
The appliance is fitted with wheels to make it
easier to move around. It can be tilted, if
necessary, in order to make transportation
easier. You should not turn the appliance back
on again for a minimum period of one hour
after performing this procedure.
Before tilting it, empty the condensed water
from the internal tank by extracting the
water drainage pipe from its housing and
removing the plug, Fig. 23. Place a
receptacle (or the appliance's removable
tank) at the end of the water drainage pipe
to collect the condensed water or lead the
pipe to the nearest drain. Do not forget to
replace the plug and reinsert the pipe in its
housing when the tank is empty.
Storage requirements
When the appliance is out of use for a long
period, set the expulsion tube to parking
position so that the appliance takes up as little
space as possible.
To do this, bend the tube towards the back
of the appliance and secure it with the
diffusion hook, Figs. 24 and 25.
44
Fig. 23
Fig. 24