Haier DW15-PFE1 Mode D'emploi page 19

Switching the dishwasher ON
Turn on the tap.
Set ON-OFF button " A " to ON, the dishwasher beeps
one time, All indicators "C1,C2,C3,C4,C5 " light .
Press programme button "B1", programme indicator
" C1" light.
If the door is closed, after 3 seconds, the programme
indicator " C1" will blink and the dishwasher beeps one
time, then the programme starts automatically.
End of programme
Six beeps will indicate that the wash cycle has finished and all the indicators light.
Switching the dishwasher OFF
Several minutes after the programme has ended:
Set main switch "A" to OFF.
Open the door .
Remove dishes, etc. when they have cooled down.
Interrupping the programme
Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open
the door fully until spray arm has stopped rotating.
When you open the door, the dishwasher will beep ten times every thirty seconds.
If the appliance has already heated up or the hot water was switched ON and then the appliance door
opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may
open due to expansion.
Switching the dishwasher OFF while underway:
Press the ON-OFF button "A" and hold it in for about 3 seconds. In other situation, set main
switch "A" to OFF.
A
C1 C2 C3 C4 C5
B1
en
18