Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
Location and Function of Controls
Remote Control Operations
Remote Control Operations
The remote control and control panel will look like those represented in the following pictures.
Cool
Energy
Saver
Fan
Dry
Timer
MODE
TIMER
3
5
1
POWER
Operation starts when this button is pressed and
stops when you press the button again.
2
TEMPERATURE CONTROL
The thermostat monitors room temperature to
maintain the desired temperature.
The thermostat can be set between 16°C~30°C.
The unit takes an average of 30 minutes to adjust
the room temperature by 1°C.
3
OPERATION MODE SELECTOR
Select cooling mode to cool the room.
Select energy saver mode for energy saving
operation.
Inserting the Remote Control Batteries
1
Push out the cover on the back of the remote control with your thumb
2
Pay attention to polarity and insert two new AAA 1.5V batteries.
3
Reattach the cover.
NOTICE
: Do not use rechargeable batteries. Make sure that both batteries are new.
• In order to prevent discharge, remove the batteries from the remote control if the air
conditioner is not going to be used for an extended period of time
Keep the remote control away from extremely hot or humid places.
To maintain optimal operation of the remote control, the remote sensor should not be
exposed to direct sunlight.
• The remote control can be mounted on a wall using the mountable holder.
10 Room Air Conditioner
˚C
F1 LOW
F2 MED
F3 HIGH
TEMP
FAN
POWER
SPEED
4
1
6
2
5
Select fan mode for basic ventilating fan
operation.
Select dry mode for dry operation.
4
FAN SPEED SELECTOR
For increased power while cooling, select a
higher fan speed.
3 steps: High
5
ON/OFF TIMER
The timer can be set to start and stop the unit in
hourly increments (up to 12 hours).
6
REMOTE CONTROL SENSOR
Power
1
Temp
2
Fan Speed
4
Timer
Mode
3
Low
Med
Publicité
