MSI K9N SLI Platinum Serie Mode D'emploi page 13

Memory
2 DDR
Specification : 184-pin, 2.5v.
Single channel definition : All DIMM slots are GREEN color.
Dual channels definition : DIMM slot(s) on Channel A are marked in GREEN color. DIMM slot(s) on Channel B are
marked in Purple color.
3
DDRII
Specification : 240-pin, 1.8v.
Single channel definition : All DIMM slots are GREEN color.
Dual channels definition : DIMM slot(s) on Channel A are marked in GREEN color. DIMM slot(s) on Channel B are
marked in Orange color.
Important
-DDRII modules are not interchangeable with DDR and the DDRII standard is not backward compatible, you should
always install DDRII memory module in the DDRII DIMM slot and install DDR memory module in the DDR DIMM slot.
- In dual-channel mode, make sure that you install memory modules of the same type and density in different
channel DDR DIMM slots.
- To enable successful system boot-up, always insert the memory modules into the DIMM1 first.
Installing DDR/ DDRII Modules
You can find the notch on the memory modules and the volt on the DIMM slots whether DDR or DDRII. Follow the procedures
below to install the DDR/ DDRII module properly.
The DDR/DDRII modules has only one notch on the center of module. The module will only fit in the right orientation.
1.
Insert the memory module vertically into the DIMM slot. Then push it in until the golden finger on the memory module
2.
is deeply inserted in the socket.
The plastic clip at each side of the DIMM slot will automatically close.
3.
40x2=80 pin 52x2=104 pin
64x2=128 pin 56x2=112 pin
Volt
Installation Guide
Notch
En-5