HQ Power HQLE10061 Mode D'emploi page 9

5.1 Control Panel
Access the control panel functions using the four panel buttons located around the display.
5.2 Menu
mode
DMX
auto
sound
speed
sensitivity
dimming
silent scene
slave
IR
5.3 Stand-Alone Mode
The device starts running in stand-alone mode after connection to the mains. This mode allows
you to use the device without controller.
5.4 Master/Slave Mode
•
The master/slave mode allows for connecting several devices to a single master device in a
daisy chain.
•
All slave devices will then work synchronously with the master device.
•
Configure all slave units before connecting the master unit to the daisy chain.
5.5 DMX Mode
The DMX mode allows you to control the device with any universal DMX controller.
•
All DMX-controlled devices need a digital start address so that the correct device responds
to the signals. This digital start address is the channel number from which the device starts
to "listen" to the DMX controller. The same starting address can be used for a whole group
of devices or an individual address can be set for every device.
V. 01 – 07/12/2020
HQLE10061
MENU scroll through the menu options
ENTER confirm a selection
UP upwards through the menu list
DOWN downwards through the menu list
programming
26CH
Addr
3CH
Auto Au1-8
Soun So1-8
SPEE SP1-SP9
SEns Se1-Se9
dIMM dI1-dI9
SILE on/oFF
SLAV Slave
InFr on/oFF
9
description
d001-d512
auto programme
sound programme
speed
microphone sensitivity
master dimming
closed/open light when no music in sound
mode
slave mode
IR remote signal reception enabled/disabled
©Velleman nv