Operation
Turning the TV On and Off
Plug & Play Feature
When the TV is initially powered on, two basic settings proceed automatically and subsequently:
Press the POWER
button on the remote control.
You can also use the
button on the front of the panel.
1
Press the
The message "Shop Mode, Menu language, Channels
and Time will be set." is displayed.
Press the ENTER button, then "Select the Home Mode
when installing this TV at home" menu is automatically
displayed.
2
Press the
then the
Then "Select the language of the OSD" the menu is
automatically displayed.
We recommend setting the TV to Home mode for the best picture in your
home environment.
Shop mode is only intended for use in retail environments.
If the unit is accidentally set to Shop Mode, press and hold the
button on the side panel of the TV for five seconds to return to Dynamic
(Home) mode.
3
Press the
the
ENTER button.
"Select the antennas to memorize" menu is
automatically displayed.
4
Press the
the selected connection.
Press the
If the antenna is connected to ANT 1(AIR), select "Air" and if it is
connected to ANT 2 (CABLE), select "Cable".
If both ANT 1 (AIR) and ANT 2 (CABLE) are connected, select "Air + Cable".
In Cable mode, you can select the correct signal source among STD,
HRC, and IRC by pressing the
ENTER button.
Contact your local cable company to identify the type of cable system
that exists in your particular area.
English-15
POWER
button on the remote control.
or
buttons to select "Shop" or "Home",
ENTER button.
or
button to select language, then
or
button to memorize the channels of
ENTER button to select "Start".
or
button, then press the
MENU
continued...