Publicité
Les langues disponibles
Les langues disponibles
Problem
No picture on the screen after
selecting a device
"Initializing D-Net" message appears.
"Exceeds the limit of device numbers."
message appears.
"Recordable device is not
connected" message appears.
"Not available while recording" message
appears
"The connected device is unavailable to
perform this function for temporary
problems." message appears.
D-Net cannot record video from analog
channels from connected external
equipment.
"Not available format is selected."
message appears.
"D-Net cannot record the picture of analog
channels or peripheral equipments for the
input source, except TV." message appears.
"The Disc is Empty." message appears.
Possible Solution
Check if the current mode for DTV and STB is set to analog
by mistake. For AV-HDD, check if the played content has
reached the end. (Select the item from the content list again.)
For D-VHS, check if a D-VHS tape is being used. If the
camcorder supports the DV format, no picture will be
displayed on the screen.
This message appears when the D-Net function is being
initialized.
Retry after a short wait to use the D-Net function.
This message appears when the number of currently
connected D-Net devices exceeds 10.
Retry after disconnecting unnecessary devices.
This message appears when the recordable device is not on the
network when you try to make a recording using a D-Net device.
Retry after connecting a recordable device (D-VHS, AV-HDD).
The message appears informing you that you cannot change
the channels or change the input source using the remote
control because a recording is in progress through D-Net.
Retry after stopping the current recording through D-Net.
This message appears when the selected function is not
supported by the relevant device or the relevant device cannot
execute the selected function. Most STBs, DTVs and camcorders
do not support the power on/off command. This message may
appear when you issue the power command for these devices.
This message also appears when the command is supported but
the relevant device cannot follow the command.
Retry after checking the current mode of the relevant device.
This message appears when the user presses the
RECORD button in analog mode.
D-Net only supports recording for digital.
This message appears when the selected device does not
support the MPEG format.
At present, D-Net supports MPEG TS only.
This message appears when trying to record analog video or video
from a device connected to the External IN port.
D-Net transmits Digital TS only.
This message appears when trying to record the contents of
AV-HDD using another device when there is no content saved on
the AV-HDD. Before make a recording from an AV-HDD to another
device, first check if there is any saved content on the AV-HDD.
English-108
Publicité
