Publicité
Les langues disponibles
Les langues disponibles
7
Lift up a section of the liner over the top of the wall leaving a 10 cm
to 15 cm (4" to 6") fringe outside the wall. Secure the liner with a
plastic coupler (sold separately). Install the top track on the wall
then install the top plates on top of each upright.
At this point, the liner may be too tight, making it difficult to drape
the overlap or, on the contrary, too loose. In such cases, you will
have to redistribute the tension in the liner by removing some of the
couplers and readjusting the liner.
228/248/278
RESIN TOP
TRACK
PLASTIC
COUPLER
(SOLD SEPARATELY)
OVERLAP
LINER
WALL
Installation detail of a bead liner with top track.
Hang the liner on the top of the wall and install the top track to se-
cure.
8
Slide the top plate on the upper side of the upright, and secure with
one (1) screw "Z".
VINYL LINER INSTALLATION (continued)
230/250/280
PLASTIC
COUPLER
(SOLD SEPARATELY)
STEEL
TOP TRACK
UPRIGHT POST TOP PLATE INSTALLATION
228/248/278
RESIN TOP
TRACK
U-BEAD
LINER
WALL
Start the vacuum cleaner to allow the liner to adhere to the wall and
check for excess tension at the bottom or for wrinkles. Adjust the
liner by removing wrinkles if needed, lift or lower it in order to ensure
a perfect fit.
Fill the pool with water up to the base of the wall before stopping
and removing the vacuum cleaner.
PUMP RETURN FITTING
After you remove the vacuum cleaner, you may install the return fit-
ting. Place the return fitting ring against the liner and adjust it so
that it is perfectly aligned with the hole in the wall. When the ring is
properly positioned and secured, cut the liner in the middle of the
ring.
Insert the return fitting from the inside, placing the first gasket be-
tween the return fitting and the liner and the second between the
wall and the liner. Then tighten the outside ring with large pliers, tak-
ing care not to crease the liner.
BOTTOM DRAIN (optional)
Find the holes through the middle of the liner and screw the ring
and gasket in against the liner before cutting the liner in the middle
of the ring, then screw on the drain cover.
230/250/280
STEEL
TOP TRACK
Publicité
