Télécharger Imprimer la page

Trevi 250 Instructions D'assemblage page 4

Masquer les pouces Voir aussi pour 250:

Publicité

Les langues disponibles

Les langues disponibles

5
Add sand. Before uncoiling the wall, make sure the pre-punched
holes for the skimmer and pump return are at the top and facing
the planned location of your filter. tration system. When installing
the steel wall, it is important to do so in a location protected from
the wind or on a day without any wind.
PLANKS
BOTTOM PLATE
Illustration 5.1
Inside of pool
BOLT
IMPORTANT! A non-compliance installation according to manufacturers' instruction will void the warranty.
A faulty installation will cause the wall or joint to split open which could result in serious and/or fatal injuries!
WALL INSTALLATION
SAND
STAKE AND STRING
End
End
NUT
Outside of pool
Begin inserting the wall into the bottom wall tracks in the middle of
a joiner plate. At first, the wall is kept in place with one or two stakes
and strings (or extra persons). One person uncoils the wall on a
beam or a plank, while a second person inserts it in the bottom wall
tracks. Do not uncoil more than 3 m (10') of wall before you install
a support bar or stake and string to reinforce the structure.
Once the wall is completely uncoiled, you may find that it is too long
or that both ends do not meet by a few centimetres. If such is the
case, adjust tracks and joiner plates until wall holes line up. If this
does not work, roll up the wall again, check measurements as per
Illustrition 1.1, adjust tracks and plates, if applicable, and uncoil the
wall again. If the spread is too wide, measure the wall and check it
against the chart below.
Join the ends of the walls by orienting folds outward to hide the ex-
clamation icon. (Illustration 8.1)
Note: If the wall is attached properly, you should no longer see
the exclamation icon. If you can always see the icon, you must
reverse the overlap.
Insert bolts and nuts in every hole and tighten with wrench (screw
head on water side of wall). Tape over screw heads with duck tape.
WARNING
Minimum torque force of 60 inch pounds to
maximum of 85 inch pounds.
Fold
Inside of pool
Outside of pool
Fold
: Never use an impact gun for wall screws.

Publicité

loading

Ce manuel est également adapté pour:

230248228278280