Publicité
Les langues disponibles
Les langues disponibles
HOW TO FILL
CAUTION: Before filling tank with water, turn the power off and unplug the unit from the outlet.
NOTE: Always use 2 hands to carry the water tank.
1. Remove the extension nozzle
(floor mode) before removing the tank from
the humidifier base. Turn the tank upside
down and remove the tank cap.
3. Replace the tank cap by turning to the right until tight. Place the tank and extension nozzle
(if used) back on the humidifier base, making sure they are firmly seated.
2. Fill the water tank with clean, cool (not cold)
water. We recommend using distilled water if
you live in a hard water area.
Never add essential oils or any other additives
to the water tank or water reservoir. Even a
few drops will damage the unit.
6
HOW TO USE
POWER BUTTON
MIST OUTPUT
BUTTON
OUT OF WATER
INDICATOR
POWER ON/OFF & OUT OF WATER INDICATOR
Plug unit into a 120-volt AC electrical outlet. Press the power
humidifier is out of water, the LED above the power button will glow red.
ADJUSTABLE MIST OUTPUT
Mist adjusts from the lowest output (1) to the highest output (3). To increase the mist output, press the
mist output
button. The corresponding mist level will be lit above the button. Continue to press the
mist output
button to cycle through the mist output settings.
MIST TEMPERATURE SETTING
To change the mist temperature from cool to warm mist, press the mist temperature
above the mist temperature button will glow red. To change the mist temperature from warm to cool mist,
press the mist temperature
button again. The LED will turn off.
NOTE: Once warm mist is selected, it will take approximately 20 minutes to heat up before the mist
becomes warm.
MIST
TIMER BUTTON
CLEAN
TEMPERATURE
TRANSDUCER/
BUTTON
ULTRASONIC
MEMBRANE
BUTTON
button to turn unit on. When the
button. The LED
7
Publicité
