Publicité
5.
Install the Handle and Plug
3/8" (1 cm)
Plug Height Adjustment
Engager le réglage de hauteur
Ajuste de la altura del tapón
Nut/Écrou/Tuerca
Screw/Vis/Tornillo
Plug/Bouchon/Tapón
Flange
Bride
Brida
Remove the handle from the packaging.
Using a hex wrench (supplied), secure the handle to the "D" stem.
Remove the plug from the packaging.
Insert the plug into the flange.
Turn the handle fully clockwise to open the drain. There should be a 3/8" (1 cm)
gap between the plug and the flange. If necessary, refer to the "Plug Height
Adjustment" procedure below.
Open and close the handle to check for proper operation of the plug.
Plug Height Adjustment
Remove the plug from the flange.
Loosen the nut on the adjustment screw.
Turn the screw to obtain the proper plug height.
Retighten the nut.
Reinsert the plug into the flange.
Installer la poignée et le bouchon
Retirer la poignée de l'emballage.
Avec une clé hexagonale (fournie), sécuriser la poignée à la tige "D".
Retirer le bouchon de l'emballage.
Insérer le bouchon dans la bride.
Kohler Co.
Hex Wrench
Handle
Clé hexagonale
Poignée
Llave hexagonal
Manija
"D" Stem
"D" tige
Espiga en D
11
1089145-2-A
Publicité
