Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
4. Attach the knob (I) to the door (H) with one M4X6
screw (BB) and one washer ø4 (DD). Tighten with
screwdriver (EE).
Hardware Used
BB
Screw M4 X 6
DD
Washer ø4
EE
Phillips screwdriver
5. Insert the bottom spindle of the door (H) into the
hole on the bottom plate (J). Hold the door in
place and put the door bracket (E) on top, as
pictured in figure 5. Attach the door bracket (E) to
the left and right side panels (F and M) with four M6 x
12 bolts (AA). Tighten with screwdriver (EE).
Hardware Used
AA
Bolt M6 X 12
EE
Phillips screwdriver
6.
Remove the control knob (P) from the burner
assembly (C) and put it aside. Lay the burner
assembly (C) upside down on a soft surface, such
as a carpet or blanket to avoid scratching. Turn the
table (D) upside down and rest it on top of
the upside down burner assembly (C).
Line up the holes on the table (D) with the
screw holes on the burner assembly (C). Attach with
four M6X12 bolts (AA) as shown in figure 6. Tighten
with screwdriver (EE).
Hardware Used
AA
Bolt M6 X 12
EE
Phillips screwdriver
4
X 1
X 1
DD
5
X 4
6
AA
X 4
12
I
BB
E
AA
H
P
D
H
J
C
Publicité
