Broan L100E Manuel D'utilisation Et D'installation page 8

5. DUCTING
(CONT'D)
5.1 B D P
lower isCharge
BO0095
NUTS
To remove blower: unplug
blower and remove
2 blower retaining nuts
5.2 h B D
orizontal lower
8" ROUND DUCT
8" ROUND ELBOW
Two ways to connect ductwork to a factory-shipped unit.
6. USE AND CARE
Ventilator is designed for continuous operation. If desired, it may be controlled using an on/off switch or a solid-state, variable speed
control. Follow wiring instructions packed with control, and adhere to all local and state codes, and the National Electrical Code.
To reduce the risk of electric shock, disconnect from power supply before servicing.
To clean grille: Use vacuum soft brush attachment or remove grille and clean with a soft cloth and mild soap or detergent. Dry grille
thoroughly before reinstalling.
To clean blower assembly: Remove grille, unplug blower from housing, remove blower mounting nuts, and carefully remove blower from
housing. Vacuum blower and interior of unit with the dusting brush attachment.
Motor is permanently lubricated. Do not oil or disassemble motor.
If the product is making excessive or unusual noises, replace the blower assembly.
ositions
isCharge
ROOF CAP
WALL
DUCT
CONNECTOR
BLOWER
BO0092
Blower and duct connector
in horizontal discharge
position. (Factory shipped)
5.3 V
ertiCal
8" ROUND
DUCT
Typical ductwork connection to a ventilator converted to
CAP
!
WARNING
8
DUCT
CONNECTOR
Change blower
& duct connector
positions for
vertical
discharge.
BLOWER
BO0093
Blower and duct connector
in vertical discharge
position.
B D
lower isCharge
ROOF CAP
vertical discharge.