Qlima PEC 2021 Manuel D'utilisation page 18

ASSEMBLING THE HEATER
•
•
•
•
INSTALLATION
•
•
Mounting
Only use the heater in hanging position. Hanging by its chain. See figure 1, 2, 5:
•
•
•
•
•
•
Operation PEC2015
•
•
Operation PEC2021
•
•
•
•
•
•
•
4
18
The manufacturer is not responsible for any harm or damage if attention is
not paid to the points described above.
The use of this product and the elements required for that purpose is entirely
at the end user's own risk.
The heating lights can be vulnerable. Make sure to handle the appliance with
care. Avoid vibrations.
Never immerse in water/liquids. Risk of death
Make sure to mount the appliance only on a firm and sturdy underground. In
case of doubt have underground checked by an expert.
WARNING - this appliance must be connected to an earthed power socket.
The heater is fitted with a supply cable and molded plug, therefore the ter-
minals should not be interfered with. The following points should be consi-
dered when positioning the heater:
Please observe the minimum safe distance between the heater body and any
inflammable surfaces. (See Fig 5).
The Hook on the ceiling hanging the Patio Heater must be able to undertake
a weight 3 or 4 times that of the Patio Heater itself.
Place the hook around the Ceiling Hook and clip on any Ring of the Chain
(see A figure 1, 2, 3) to adjust the height of the Patio Heater to the Floor.
Only operate the heater when is it in the upright position.
Connect the power cable to a suitable socket (refer to rating label) that is
located in a safe, dry area.
Tide up the over length of the power cord with a tie wrap (see figure 4)
CAUTION: make sure the powercord can never touch the heater.
Heater is equipped with 2 heat settings: Low and High.
Low power (600W): pull the Switch Cord once. Once the Switch Cord is pul-
led, the bigger top heating element will glow and radiate heat.
High power (1500W): pull the Switch Cord again. This will cause both the
bottom and top heating elements to glow and radiate heat.
Heater is equipped with 2 heat settings: Low and High.
Place 2 x AAA batteries 1.5V (not included) in the remote control.
Before using the Remote control make sure the heater is switched on using
button I (figure 2)
(I) position for turn on. (0) position for turn off.
remote control (see figure 2 item J):
Press one time for 900W,
Press again for 2100W (900W+1200W).