Publicité
Les langues disponibles
Les langues disponibles
11. Do not use the device nearby or facing furniture, curtains, paper, clothing, bedding or
other flammable materials. Keep at least 1 metre from device!
12. Do not use the heater outdoors or in areas that are smaller than 15m³.
13. The device contains hot and/or glowing and sparking components. Do not, therefore,
use where fuels, paint, flammable fluids and/or gases are stored. Do not use the
device in an environment that poses a fire risk, e.g. near gas tanks, gas pipes or
aerosols. This is an explosion and fire risk!
Warnings – use
1.
Do not use additions/accessories on the device that have not been supplied or
approved by the manufacturer.
2.
Only use the device for its intended purpose and in the manner set out in this
instruction leaflet.
3.
Some parts of this device will get very hot and could cause burns. You must pay
particular attention to children, vulnerable persons and pets that are present near
the device. Never leave them alone with a working device.
4.
Never cover or block the device; it will overheat and this could lead to a fire risk.
Never hang or place objects such as clothing, blankets, cushions, paper, etc. on the
device. The minimum distance of 1 metre between the device and flammable
materials must always be applied. Ventilation openings should never be blocked as
this may pose a fire risk. Never use the device to dry clothing or place anything on it.
Do not let anything lean against the device!
5.
Do not set the device to come on automatically using a timer, clock or other facility.
You must always check for safe conditions before using the fireplace! Never use the
device with an external voltage regulator such as a dimmer or similar, as this could be
dangerous!
6.
The connection voltage and frequency, as given on the device, must correspond to
that of the socket to be used. The electrical socket to be used must be an earthed
connection. The electrical installation must be protected via a 30 mA earth leakage
circuit breaker. The electrical socket that you are using must be to hand at all times in
order to be able to remove the plug from the socket in the event of an emergency.
7.
To avoid overloading and/or fuses being blown, do not use any other equipment on
the same socket or electrical group as the one used for the device.
8.
Unroll the electric cable for the device fully before inserting the plug into the socket
and ensure that the electrical cable does not come into contact with the fireplace or
get hot.
Do not run the electrical cable under carpet, cover with mats, runners or similar and
do not place in areas that are walked on frequently. Ensure that it cannot be stepped
on and that no furniture is placed on top of it. Do not bend the electrical cable
around sharp corners and do not roll up too tightly after use! Prevent the electrical
cable coming into contact with oil, solvents and sharp objects. Check the cable and
plug regularly for damage. Do not bend or pinch the electrical cable and do not wind
it around the device; this could damage the insulation!
23
Publicité
