Chauvet DJ INTIMIDATOR BEAM 360X Guide De Référence Rapide page 2

EN
Safety Notes
These Safety Notes include important information about installation, use, and maintenance of the Intimidator Beam 360X.
■ ALWAYS:
♦ Connect to a grounded circuit.
♦ Connect to operating voltages as specified on the product's spec sticker.
♦ Disconnect from power before replacing the fuse.
♦ Disconnect from its power source during periods of inactivity.
♦ Use a safety cable when suspending overhead.
♦ Heed all restrictions and warnings on the spec sticker.
♦ Mount in a location with at least 20 in (50 cm) of ventilation.
♦ Replace the fuse with the same type and rating.
♦ Use a clamp with a captive bolt when a single hanging bracket is used.
■ In the event of a serious operating problem, stop using immediately.
■ DO NOT:
♦ Open this product or attempt any repairs. It contains no user-serviceable parts.
♦ Look at the light source when the product is on.
♦ Use if the power cord is crimped or damaged.
♦ Disconnect by pulling on the power cord.
♦ Allow flammable materials close to the product when it is operating.
♦ Touch the housing when it is on.
♦ Block any ventilation holes/slots in the housing.
♦ Connect to a dimmer or rheostat.
♦ Carry the product by its power cord.
♦ Operate in temperatures higher than 104°F (40°C).
♦ Expose to environments that exceed the Ingress Protection (IP) rating.
♦ Expose to rain or moisture.
♦ Use outdoors.
♦ Submerge.
♦ Set this product on a flammable surface.
What is Included
♦ Intimidator Beam 360X
♦ Power cable
♦ Hanging bracket
♦ Quick Reference Guide
Control Panel Description
Button Function
<MENU> Exits from the current menu or function
<UP> Navigates upwards through the menu list and increases the numeric value when in a function
<DOWN> Navigates downwards through the menu list and decreases the numeric value when in a function
<ENTER> Enables the currently displayed menu or sets the currently selected value into the selected function
1
QUICK REFERENCE GUIDE
Intimidator Beam 360X QRG Rev. 1